Solution Graphics
This area does not yet contain any content.

Discussion > O Scale Gore Engine House Question

I"ve been working on the Gore Engine House (o scale) and ran into a problem where not all the pages are to the same 'scale'. I thought it was a printing issue but after multiple reprints with the same results I imported the pages into photoshop and overlaid them and can confirm that the parts aren't all to the same 'scale'.

This is most obvious when when lining up the roof components, the interior ends being smaller vs the roof supports, and the doors seem oversize when compared to ends as well.

unfortunately I didn't realize this until I'd already invested a lot of hours into making sub-assemblies.

Has anyone else run into this?

Thanks,
Rob
February 15, 2015 | Unregistered Commenter-Rob
Rob, from disc or download. need to know so i can check the files. This has not surfaced before and the engine house has been built many times over the years.
February 16, 2015 | Registered CommenterDave
Hi Thom - files are from DVD. I emailed you a couple pics to show what I'm referring to.

Thanks,
Rob
February 17, 2015 | Unregistered Commenter-Rob